z bar identification

Discussion in 'General Maverick/Comet' started by supermav, Jul 1, 2009.

  1. supermav

    supermav Member

    Joined:
    Dec 2, 2008
    Messages:
    267
    Likes Received:
    30
    Trophy Points:
    122
    Location:
    clarkston wa.
    Vehicle:
    71 grabber,65 galaxie drag car,66 fairlane 2 door hardtop,64 falcon ranchero
    pulled from v8 mav but is a 1 peice.is it a mav peice? 002_original.jpg 001_original.jpg
     
    supermav, Jul 1, 2009
    #1
  2. mean_maverick

    mean_maverick Senior Member

    Joined:
    Aug 29, 2005
    Messages:
    7,312
    Likes Received:
    11
    Trophy Points:
    153
    Location:
    Irvine, Kentucky
    Vehicle:
    '73 4dr
    looks like someone has made their own. it has the same bends as a factory but like u pointed out, it's a one peice
     
    mean_maverick, Jul 1, 2009
    #2
  3. mercgt73

    mercgt73 Member Supporting Member

    Joined:
    Sep 6, 2003
    Messages:
    3,831
    Likes Received:
    359
    Trophy Points:
    223
    Location:
    Eastern Shore, Maryland
    Vehicle:
    1973 Comet GT (clone), 1974 Mustang II, 1980 Bobcat Wagon
    its been a while... but I remember mine also being a 1-piece. but i could be mistaken. it came out of a junkyard 3-speed mav/comet. are they not usually 1-piece?
     
    mercgt73, Jul 1, 2009
    #3
  4. mean_maverick

    mean_maverick Senior Member

    Joined:
    Aug 29, 2005
    Messages:
    7,312
    Likes Received:
    11
    Trophy Points:
    153
    Location:
    Irvine, Kentucky
    Vehicle:
    '73 4dr
    factory they're a 2-peice design with a center bolt that holds them together
     
    mean_maverick, Jul 1, 2009
    #4
  5. dmhines

    dmhines Dixie Maverick Boy

    Joined:
    Jun 24, 2002
    Messages:
    8,927
    Likes Received:
    22
    Trophy Points:
    147
    Location:
    Cumming, GA
    Vehicle:
    1971 Grabber / 2012 Mustang / 2009 Jeep Wrangler / 2013 Ducati / 2009 Buell XB12Scg
    I'm at work with no pics ... but that could be a 250 z-bar ....
     
    dmhines, Jul 1, 2009
    #5

Share This Page