Grabber hood inserts- installation?

Discussion in 'Technical' started by gdemopesq, Feb 3, 2008.

  1. gdemopesq

    gdemopesq MOTOR CITY MAV

    Joined:
    Nov 4, 2007
    Messages:
    387
    Likes Received:
    22
    Trophy Points:
    66
    Location:
    Michigan
    Vehicle:
    72 Maverick 302
    Ebay has a set for sale. If I got them are they bondo'ed in or cut, or something else?
     
    gdemopesq, Feb 3, 2008
    #1
  2. mav1970

    mav1970 Bob Hatcher

    Joined:
    Mar 9, 2002
    Messages:
    10,633
    Likes Received:
    322
    Trophy Points:
    398
    Location:
    Mountain Top Pa
    Vehicle:
    69.5 Maverick 393 Cleveland Stroker
    They are bolted into factory cut out holes. You're not thinking about using them on a stock flat hood, are you? They only fit the Grabber Hood.
     
    mav1970, Feb 3, 2008
    #2
  3. gdemopesq

    gdemopesq MOTOR CITY MAV

    Joined:
    Nov 4, 2007
    Messages:
    387
    Likes Received:
    22
    Trophy Points:
    66
    Location:
    Michigan
    Vehicle:
    72 Maverick 302
    Well that takes care of that question
     
    gdemopesq, Feb 3, 2008
    #3
  4. don graham

    don graham MCG State Rep

    Joined:
    Mar 10, 2002
    Messages:
    15,800
    Likes Received:
    16
    Trophy Points:
    302
    Location:
    arizona city, az.
    Vehicle:
    70 mav, 71 grabber, 73 Comet, 2004 f-250 crew cab diesel, 2001 f-250, 2004 explorer, 2007 Gold Wing trike.
    Yeah, there held in by a couple of nuts. The hood is shaped for them.:)
     
    don graham, Feb 3, 2008
    #4

Share This Page