That is another story but, I think it's going to have a happy ending. I purchased the adapter when I bought the carb. I knew that clearance was...
I have just a few problems/questions that came up. I gave the folks at Lokar a call and they said I would still need to fabricate a bracket to...
I have a 73 Maverick with 250. I was looking for a inexpensive upgrade so followed the Tech article Putting a 2bbl carb in your I6 (great...
Mystery solved I called the Technical line at Pertronix and explained the situation. They said that behind the tape were six little magnets. I...
Sort of it has a some blue plastic..do I need to remove it?
I just went out and put on the old rotor, no better. I then put the new rotor with the old cap, no better. You got me thinking so I pulled the...
I purchased a new rotor when I got the cap, so yes I think it is clean.
I have a very unusually situation that has me really stumped and I wanted to see if any one has had a similar problem or can offer a solution. I...
I have a 73 Maverick with a 250 and a Carter RBS carburetor the heat riser tube is long gone. I cann't even tell where it attached to the exhaust...
I ended cutting it about 4 inches from the bottom pasenger side corner and about 6 inches up the side. The 2 door rear window is slightly smaller...
It sounds like you are doing a lot research than I did. I mistakenly thought that the 2 and 4 door was the same and of course, they are not. By...
Got the pictures.....:clap: thanks! When I pulled the spindles I pulled the valve at the same time from a 76 Granda.....the mfg is wagner. But...
Here is a picture I have attached a picture. I know two lines go to the master cylinder...I imagine one for the back and the other two go to the...
I am in the process of putting disk brakes on my 73 Maverick that I pulled from a Granda I remembered to pull the proprtioning value as has been...
Maverick connection Seth, thanks for the info :) ......do you have another phone number for the Maverick Connection. The number I tried gave...
I have a 4 door Maverick that I am restoring and I have run into a brick wall. I painted the car and removed the rear glass to paint and install...
Yes, that is what it was like. My dad was helping me the first time it happened and his hand was shaken so violently that the nail of his thumb...
:2thumbs: Hey, thank you so much! I checked the hoses and reversed the hook up and it worked great!! I was able to test drive it around the...
I will look into that, I did replace the control valve, but it possible that it is out of adjustment. Thanks for the info....
I replaced the idler arm already. Thanks
Separate names with a comma.
