I looked at RockAuto and they have the switch for the 1970 Maverick, but not '71 or '72. What are the differences in the switches?
So I have been driving my 1972 Grabber almost every day for 2 1/2 months with a POS turn signal switch. I was able to wire a toggle switch into...
Eagle 1 wheel etcher works really well on cast aluminum. I've used it to clean dirty aluminum mags, intakes, and even the aluminum k-member from...
I ordered the MOOG K8233 shaft kit.
Thanks for all of your help! The shaft kit didn't come in today, so I will continue with it tomorrow. Oh yeah, the spring was definitely out!...
So my passenger upper control arm bushings squeak with every little bump. I ordered the MOOG kit from OReilly's to replace the rod and use rubber...
Hey I found out today that the bolt pattern for the small bearing end on the 8" is similar to the 8.8 ends, but will not bolt up. The holes on the...
Bryant, So are you saying that the 8.8's had different bolt patterns? The bearing end on my 9" housing uses the 8.8 bolt pattern shown in the...
Thanks Eric! I wish I would have paid more attention and asked that question before I had the rear end made with the smaller axle hang out. :cry:
I'm working on my 72 Maverick Grabber and ran into an issue with the bolt pattern for the bearing ends. The car came with a six cylinder and four...
Separate names with a comma.
