:Welcome: from south central PA.
I saw the title "Died while driving". Was hoping you didn't mean the driver...:Welcome:
Ahh, ok I see now, thanks. So the Toyota shares the same lug bolt spacing as Ford?
? The front hubs and rotors on our cars are one piece. Unless you mean the steering knuckle/spindle.
It should work. He mentions that it is only for drum brake cars, not factory disc equipped cars. Maverick drum spindles are the same as '70...
When I made my bar the idea was to try and incorporate both types of bars into one solid, welded piece with only straight bars. The cross piece...
The cars in the background are from a picture taken at Roundup in 2012. Little bit different angle here. [ATTACH]
My '70 originally came with 9" drums all around. After putting in a V8 the braking was so poor I actually had nightmares about it.
I got a flat tire once on my way to Roundup. Found out the hard way my spare tire wheel didn't fit over my disc brake hub. :slap:
Since I don't have a distributor anymore I thought about running a bar from side to side in front of the throttle body but I didn't want it to...
I have a MeterMatch module on my fuel gauge to dial in the calibration. I guess you could run any arm and dial it in with that. I see they cost...
I've been considering that as I have a '70 Mustang tank in mine with my FiTech. Would free up some room in the engine compartment if I remove the...
How it looks now with the FiTech and distributorless ignition. [IMG]
[IMG] [IMG] [IMG]
Didn't know that myself until I was putting together a 347 stroker one time with a D4 block and pistons were down in the hole. Looked it up. I...
D4 block used from 74-77 had a .023 higher deck height than blocks before and after.
Just started reading this. Pistons .040" down in the hole, with an early 302 block and stock pistons? The only time I've seen anything close to...
Looking at the front of the solenoid, the left small terminal should get 12 volts from the ignition switch and the right terminal supplies 12...
There's a company that makes a strut conversion for our cars. NICKDOMINIC on here has one. Don't remember the name of the company or details.
Just a thought, does your solenoid have 2 small wires going to it and could they have gotten switched when you installed the new solenoid?
Separate names with a comma.
