The sensor needs to go where the copper line is now. The original part that looks like a sensor (3) is probably just a switch for the dash light,...
533 hp and 800+ lb ft of torque. LOL
That's what I have. Ran a 3/8" aluminum line back to the fuel filler neck for the vent.
That means an injector was being held open, would run really rich. Was that the problem he was troubleshooting? My GF's Nissan 300ZX had a stuck...
https://www.hagerty.com/media/news/the-new-crate-motor-by-ev-west-and-revolt-fits-just-like-a-small-block-chevy/?utm_source=Taboola&utm_medium=nati...
"Go Go Godzilla..."
Exactly how I did mine many moons ago. Got two rear regulators with motors off evilBay for $75. Had to replace both motors since then. They have...
I have Autometer electric gauges. I had an oil gauge leak inside the car once, not from the line but from inside the gauge itself. Shot hot oil...
Back from the dead... Were you able to put the springs between the upper and lower arms like you'd hoped? That's a pretty car!
I agree, grease shouldn't have been used. I bought the car when it was just 2 1/2 years old from a used car dealer. During the test drive the...
I had the same problem but mine was caused by old grease inside the switch getting hard and not allowing it to move counter clockwise. Took it...
It depends on your combination of engine size, cam, trans, rear gears, car weight. For example, a heavy car with a small engine and tall rear...
5.0 w/Edelbrock heads and 6901's in my '70. Unbolt the motor and raise it a few inches. Push the engine over to the passenger side and install...
When I went to a floor shift I disassembled the column, removed the shifter tubes and linkage, Cut off the shift lever and nub and did some "body...
I just have my fan wired directly to the battery through a circuit breaker. When the engine is turned off it'll cycle on and off a couple times on...
When/why do you turn the fan power off?
Yep. Just have to assUme that if the fan has power it's running.
I had an LED on mine to show when the high speed turned on. Wired right to the high speed relay contacts. What I found was the LED was bright...
Here's the thread. He starts talking about it in post 298 but all of the photos are gone....
If Dennis ever gets his Comet finished, he has that. There's a thread on it somewhere.
Separate names with a comma.
