That intake in the video does have a thin flange compared to other intakes. Still the first I have heard of a warpage issue but that right there...
You will not have any issues, they have be doing it about as long as there have been aftermarket parts. Cant speak for the warpage with a Weiand...
Goes to show how deep my knowledge goes!:slap:
To my knowledge the deck height of the 302 has never changed, always be 8.2". It is possible the compression height of the piston was reduced to...
I would say there are two things that should give you your answer. 6901's are known to fit the Maverick and if you found a guy running them on P...
Did some sand blasting and painting. [ATTACH] [ATTACH]
I did some searching and tail housings for the three speeds are few and far between. There was one for an early Mustang on ebay for a reasonable...
I would have to agree, it would get the shifter where it needs to be and is a much better shifter. Swapping the tail housing on a three speed is...
Why not return it and buy the better piece? Does your tail housing have bolt holes at the back by the driveline? If it does that's the way I would go.
Didn't know that, if that's the case he would be stuck with the Indy.
Maybe the Mastershift would have been a better choice, they have one listed for the Ford three speed. It would be more like an original shifter...
You shouldn't have to cut the support, the shifter should mount near the end of the tail shaft housing. [IMG]
Tell that to the Australians, those guys have a lot of performance four doors.
You will want the frame brackets, engine mounts, belly bar and transmission cross member. All of these are bolt on parts that came from Ford with...
You can run that as is unless you plan on hard launches with drag slicks. It's just a good idea to stiffen it up with additional power and...
Opened them up quite a bit!
Did you come across this one in your research? http://mmb.maverick.to/media/flip-up-71-73-mustang-gas-cap.17149/
That's very cool!
Did you bust the nut on the backside loose? I was fighting mine until I did that, all I was doing was spinning both nuts and the sleeve inside the...
It just peeks into view at 12:40 and he makes the comment it looks like a Mustang 2 or something. [MEDIA]
Separate names with a comma.
