Old mechanics trick. Lay your palm against the side with vac advance pot and wrap your fingertips around the back of the distributors housing....
Frank.. if you think that's funny?.. try reading it on a smart phone! :whew:
Don, where'd you finally end up with your carb and ignition tuning endeavors? Here's my take on cooling system requirements. IF the cooling...
Looks like another big plus for Dakota Digital, Frank. Glad you finally got it all sorted out to do what you wanted.
With the airfoils improved height.. those look like they'd actually work compared to the lower profile plastic ones made today which have never...
I suppose anything's possible if you're creative enough, Frank. Just be sure to check amp ratings however you decide to go. Good luck with it!
I don't see how that would even be possible unless you have a severe restriction in the induction system. WOT should produce 0" of manifold...
I'd guess a remote filter would be just about mandatory if he want's a legitimate shot at making it work with stock suspension. Or if not?.. to...
Don't see why not and think it'd be safer feeding off the relay than before it.
Figured I'd follow up here in case it helps you out at all. Got a set of Trick Flows 170cc 11R heads and I was stunned at the technically...
Not sure which exact part my bud's bro-in-law used for his LS conversion but I see there are TONS of LS conversion pans out there these days....
Been so long since I actually laid eyes on it had to pull the car cover off just to make sure it's even still under there. Still buying and...
It may not be a problem Frank, but the only thing I'd be slightly concerned about is the load draw/amperage spike going through the switch when...
Maybe you overheated trying to keep up for pictures? Lol Seriously though.. have you ever tuned this motor with a vac gauge and timing light to...
Can't you just install the vac switch after the fan.. and before the a/c clutch? Shouldn't matter if you have the fan and a/c clutch in series or...
Ok, then go for the superior adjustable vacuum switch to cut a/c clutch anywhere between 1-6 or 6-22 inches depending on which unit you decide on....
Several options, Frank. Best would be to use one of your ecm outputs(can't remember which one you have.. grid? Not sure what rpm based options...
Like Frank mentioned.. considering the steering component design/layout under these cars, I'd think you'd be into rear oil pan clearance mod's...
Good catch there, Larry. This is why it's so hard to help on a forum. Things get breezed over when people come flying through, terminology is...
In a perfect world you can get close by using the typical factory setting. But it's far from a perfect world with these old motors so you should...
Separate names with a comma.
