"dust-less" yes.. mist-less no. Kinda silly to imagine water based blasting warps sheetmetal unless maybe you use a hot water blaster. lol I...
Cool. Now that you're all practiced up.. how about a render my Comet GT! :D
Maybe you're done with this project already but my best advice is to ALWAYS use very small dabs of RTV or Hylomar at timing chain cover/5th main...
Frank makes a valid point with his question. Hope he's a damned skilled AND conservative style driver at 16. Not likely for a 16 yo but there are...
Nice work Nick. Hopefully you'll wrap the tube above that filter or run a remote filter setup! Gonna be hot hot hot! lol Hedman header choices...
Maybe in a pinch?.. but otherwise those are horsepower and torque corks! Old school factory manifolds are for bone stock factory iron from...
I've seen several people retrofitting S10 valances onto their cars. Can't rightly remember what year range so won't even hazard a guess but...
Too bad more people don't pay closer attention to posts like this. ^^^ As I've stated many times to various gearheads theough the years that...
I love hood mounted tachs! Plan on making my own and also adding a shift light to mine.
Check rotor phasing is correctly oriented towards #1 tdc compression stroke. My guess is a sheared roll pin on the distributor gear. Been there...
IMO, you have some major tuning issues going on there. TONS of combo's like that running around happily on pump gas with WAAYYY more than 8°...
I have a quick question or two before I toss my dirty penny in. Square jetted? 68 front and rear? Also, how did you get your mechanical sweep...
Those coilovers look pretty sweet! I have the SPC arms but would like to mod them for a lower control arm mounted coil over setup like many of...
I sometimes scroll over members birthday notification icons to see what's up and send well wishes. Today I noticed the sheer number of folks who...
Easy to correct that hot mess by retarding the distributors currently clocked position and swapping plug wires to their new positions. And I've...
Pretty easy to be off a tooth during distributor install. Repeated cranking just floods the engine till it goes boom. And too much of that wipes...
Exactly right, Tom. In fact, the vac advance pot is the LAST thing to be tuned in the overall tuning process. It is purely supplemental and...
Need to baseline the tuneup and check overall engine condition with a compression check. This includes noting the current carb calibration(front...
Depends on a few factors, gear ratio being a biggie.. but many engines can run completely locked timing of 36 degrees and have no issues. These...
That'll work. Will be fine with regular motor oil too. Cam lube is mainly used because of its high viscosity which helps the oil cling to the...
Separate names with a comma.
