It will also give you the opportunity to check for an out of round tire or a bent rim.
The infamous, "courtesy check". Take your car to most any shop (Firestone, Goodyear, Ford dealer, Pep Boys etc) and they will find wear...
I bought Summit wires for my 306 and they were pre-crimped to length. Fear not, I bought "raw" wires for my old BBF drag boat and cut them to...
Let us know what you are looking for. If we can bag a bargain at the S&D rack that can help a fellow MCCI member, it makes us all better.
Had to use my Silverado 4x4 to get out of our 600' driveway today. I'm getting soooo flippin' tired of this winter!!!! May be going back to...
That is the thing that confounds exhaust system designers.
Looking forward to some pics of your PHB fab. It worked very well on my 2006 Mustang GT even though it had coil springs.
Thanks to all that came out to Mike's Place for our mid-winter Mini Meet. It was nice to meet new faces and get reacquainted with people we have...
The Akron store has their S&D sale next week. The Akron sale has turned into a bonanza of sorts for re-sellers (Ebay) and that is too bad, since a...
See you there, Don. I'll probably get there before 2:00 to make sure we get some seats.
[ATTACH] I had my rear bumper and the boomerangs plated by Jon Wrights in Grafton, Ohio. This place is super expensive, but the work is better,...
FedEx Ground dropped off my new Moog UCA's. Didn't have to drive his truck out of my long icy driveway this time.
I'll have to get them out and take a few. They look awesome.
Picked up my rear bumper and boomerangs from the plating shop.
I was thinking the same thing, Allen. That is, until I saw the job Coop did on his Comet. After seeing that, I decided to retain the halo trim and...
You mention that the carb is new. You might have to take it apart and see if the float is adjusted properly. You may have very little fuel in the...
If you were describing a marine engine, the symptoms would indicate classic vapor lock. If the fuel is getting too hot for any reason or if the...
Given that you are in Ohio, I would recommend soaking the bumper bolts with PB Blaster or other penetrating oil and let it soak in for a few days.
Just a reminder that there is an MCCI Mini Meet at "Mikes Place" in Kent, Ohio this coming Saturday. A great opportunity to interact with your...
Scored a set of Hooker 6901-1HKR's with ceramic coating from Summit's demo rack.
Separate names with a comma.
