AutoKrafters
The OEM center-link has a sponge rubber bushing, between the rod end and the Pittman arm. When removing, try and save. It's difficult to do,...
From time-to-time, I’ve read posts concerning electric fuel pump wiring and/or installation of either an aftermarket electronic ignition, or a...
Welcome from Salem, Oregon!
Oye! What state are you in? I'll be in Jalisco (Guadalajara) on Nov 8th......getting married to novia.
Maybe too far and cost too much to ship, but I saw a 9" rear-end out of a Galaxy, on Craigs List in Salem, Oregon for sale, today.
Salem. Oregon says "Welcome"! :cheers:
Hello from Salem, Oregon! :tiphat:
Hello from Salem, Oregon! :bouncy:
I'm not sure how much "real estate" you have, between the block/fire-wall/fenders. I used a brass "cross piece" (shaped like a "+". I used a...
I'm going to Mexico in November. My novia lives there (We're getting married in Jalisco). I will look them up, too.
I bought the center section, and returned it!!!!!!!!!!!!!! Close examination: they are certainly made from a "real" Maverick Grabber lip spoiler....
I've had very good results with Classic Inline! :clap:
I found this web-site information helpful, to repair the center section: http://www.tech-cor.com/AutoResBulletin/1990-1/1990-1.htm
I have an extra manual brake rod, if you need. Just pay shipping. PM
Welcome Welcome from Salem, Oregon! :yippee:
I6 Build-Up Everyone has pretty much covered all the modifications. Replacing your "stock" non-adjustable 1.5:1 rocker arms with a 1.6:1...
Perhaps another method would be to use a heated soldering iron to melt holes. I think I still have a scrap left to try it out.
:slap: Now ya tell me. I have one of those. I'm going to "try" to squeeze the tube part into the tool, and punch 1/2 diameter, right at the...
I installed a new trunk-lid gasket. Now, the lid sits very high. After letting the gasket compress, it slowly has gone down, but every time I...
Separate names with a comma.
