It will be the same for a 72 and the type of engine. Being a Grabber would not change the spec.
Use 5 quarts with filter change. I use 10-30 weight oil which works for me.
I thought 74 you ran unleaded? I could be wrong.
Check the speedo gear going into the trans. If its good replace the cable.
If you need another 250 I have one.
You're right quality as gone down. When I built my 205 I went through 3 gas pumps to find one that works. I got them from napa. I also had to fix...
Try power washing. That would take care of a lot of curd than you can repaint it.
I also have a plug. Do you want to come over and pick it up? Email me if you want it.
As far as I know no one makes the trim. You need to find uses ones. I do have the trim and headlight bezel you need. Email me if you want it.
You need a tank from 71-73. If you still need one let me know I have one.
Have you replaced the solenoid? It sounds like it bit the dust.
I had the same problem. I replaced the spring perch and the shocks would not go in the lower arm. I used a floor jack to raise the lower arm and...
Try this, disconnect both wires to the oil and water sensor and see if the light goes out. Than connect one of them and see if the light goes back...
Yep, I go with new solenoid.
The problem with armorall is once you use it you have to keep using it. There is some chemical in there that if you use something else the surface...
I have a 250 if you want it. Email me I'm close
Glad you figured that one out for the intake.LOL You can unbolt the exhaust pipe on the manifold than remove the head.
Get some rust mot. I use it all the time works great.
The gas tanks interchange from 74-77 for Mavericks and Comets. If you are going to replace it I have one. Email me if you what.
Wait until the engine is cold. That is the recommended and its in the owners manual. I use 10-30. I think its better than a straight weight oil.
Separate names with a comma.
