Sitting on a whole field full of four leaf clover? Because you're one lucky s.o.b. if you haven't wiped out a camshaft by reusing lifters on...
Is that a Circle D?
Where's the fun in that?!?!?!?!?!?! :rl:
All the makings of a nice, home-grown, terrorist. :rofl2: By the way.....you do use frozen carrots, right? If not, that's a hint. ;)
Supply and demand.
His words......not my idea. On the flip side........there is something deeply (and deviously) satisfying about outrunning someone's "badass...
As far as the cylinder heads.......if the OP keeps the original heads I'd suggest going with 1.84" intakes and 1.54" exhaust valves. No sense in...
As with all things automotive........"it depends." :cool: Should he plan on this just being your average daily driver type deal then he could...
Cheapass. Then again.....I believe I've said that before. :rofl2:
Were you wanting cast, hypereutectic, or forged pistons?
You're screwed. You think cars are expensive? Kids are THE MOST EXPENSIVE hobby known to mankind. Just fill it back up at 1/2 tank and do the...
Cheapass. :biglaugh: Only tanks used with carbon dioxide (C02) can be used in nitrous applications. Different flow valves though. Just buy the...
I'll bet it does!
Pull the pan? Hell...pull the intake and check. Simple. I'd still swap the two barrel for a 570-ish cfm four barrel. You'll end up with better...
Unless the bolt diameter was too small and it allowed the starter to walk while cranking. I'd definitely swap the bell out.
Don't take this the wrong way but you need to do some serious research before you pull the trigger on anything. Based on this post you don't even...
Yes, they will fit. Mill them .020" to bring the compression up just a bit and you're set.
You already own the XE268H. With the 1.7 rockers it will make excellent power. Good cylinder pressure and still have good top end power.
Out of all those you've listed I'd go with the XE268H. Should be very responsive with the shorter duration numbers and very good lift with your...
Either pipe or tube stock and 3/16" plate....fabricate your own.
Separate names with a comma.
