I bought a six-shooter of the RB a while back, didn't use a few of them. I've got some projects to take care of and I'm debating using these old,...
Could this be the shift-o-matic or whatever the manual valve cars were?
Is it a column or a floor shift?
Lots of folks have replaced their bulbs with more efficient/brighter LED lights, some have gone as far to paint the inside of the cluster (behind...
Is there a reason no one has tried a swap with one of these? It's only an inch wider on each side than a stock maverick rear. I know you would...
A friend of mine has hi-po crossover headers on his mav, the steering hits a bit, but they work.
Unless these are the ones: http://www.dougthorley.com/cartgenie/prod-100.htm
I'm going to ditch the 6901's on my car when I re-do the exhaust this year, and I am looking into shorties. I saw the Hedman 88400's, but I recall...
Everything else seems good.
Gallery attachments are loading VERY slow for me, or not at all.
Looks similar to this kit, I wonder if this is where it was adapted from.
There is also a clutch safety loop wire available in the harness, even on automatic cars.
With regards to comfortweave, I was looking at an office chair at work recently and I noticed it had a woven vinyl back VERY similar to...
Great feature guys!
Nice slots, can I run those without them rubbing?
Nice to see they cleaned off all the packing tape that was holding the top windshield trim on during Power Tour 2010.
I replaced my calipers, bearings, rotors, pads and soft lines recently. After getting the car on the road, I noticed the steering wheel twitches...
I have a turn signal cam sitting around from a '77. My car is a '71. The plugs and mounting holes look close, has anyone ever tried swapping early...
Lindsey and I got home safe after an afternoon of walking around Hannibal on Sunday. We ran into Doug and his wife quite a bit in the shops!...
Just finished loading up, will be rolling in just after the car show starts tomorrow.
Separate names with a comma.
