I am concerned about where those wires go and what they feed. I have identified all but a few. The last thing I need is a massive short and melted...
There is a switch mounted to the valve cover on the driver's side with 2 vacuum lines and one electrical connector. I see no reference to this on...
Success! After tracing down the wires and replacing various elements, I got power to the starter finally.Thanks to all who helped on this. The...
I am trying to track down an ignition problem. I cannot get any juice to the starter so I am eliminating as many sources as possible. On the early...
I have a 72 Maverick column shift and their is no switch on the tranny. After searching many posts, I assume it is on the column down low. How...
I am going to disconnect the refrigeration unit on my Maverick for now so I can deal with other issues. Since this system is supposed to be...
I usually go the GenStar which rebuilds starters, generators, alternators, etc. in lieu of buying an assembly line rebuilt one. These guys have...
Actually, the lock washer is on the starter housing side so that is steel. I was concerned about length to ensure there was enough shank going...
Well, I got lucky! I kept working the bolt back and forth and finally got it free from the nut placed on the end in the back of the bell housing....
I went to replace the starter on the Maverick 200 and the top bolt near the block apparently is an alien. Someone apparently trashed the threads...
Maybe it is time for a carb rebuild. Most likely you have a Carter YF on there.You can get better performance and quicker starts by switching to a...
The 2 smaller wires hooked to the solenoid have different color rubber boots. One is blue and the other is black but the wires on both are...
Anyone have a wiring diagram for a 72 Maverick? I will have to trace down the path from the solenoid switch into the dash area due to some clown...
70 Gas Tank w/ Sender 71-72 Gas Tank w/Sender Column Ignition Switch Upholstery Kits(exact colors) Carpet Kits(exact colors) Door Panels(exact...
I noticed this immediately when I started repairing the brakes, tuning the car and removing excess stuff not needed in the engine bay. I am...
Well, actually both sides of my front fenders have weak spots on top about 1/3 of the way from the front. When I lean on the right side, it...
Other than a few pin holes in the rear floor due to a broken window and many monsoons, the car is rust free. I only paid $100 for the beast and it...
The 200 in there right now is in decent running condition but at some point will have to be rebuilt. This car sat for over 10 years in a back yard...
For right now, I will just use the stock head since this car will be a daily driver. At some point in the future, I may use the OZ head that is...
Somewhere in the future, I will be swapping out the 200 for a 250, so I need some info on any changes that will be needed.1) tranny and engine...
Separate names with a comma.
