Comp Cam 282s
Valvoline 30w with the comp cam zinc additive
I did, a bit. New cam is slightly smaller than the last but tighter lobe seperation. Seems to run a bit quiter than the last. Nice lopey idle...
I just finished the "cross your fingers run it at 2500 for 20-30 minute" new cam break-in. Other than a small valve cover leak all looks good....
For a solid paint job w/ body work, that is not a bad price. (not even at 5k)
My turn? 1968 302 .030 over, 10.25 comp, Comp cam 282s, edelbrock rpm's, speed demon 650, long tube 1 5/8, Scott
Laeey, I agree. Comp has an aditive that I bought for that very reason. In fact,with the cam came a long letter talking about todays oils. Almost...
**Problem Solved** I was lining up the pushrods to see if any were bent and low and behold, one was missing the "cap" on th end and YES it was the...
I appreciate all the thoughts. The cam is the same one I have ran for over 20,000 miles over the last 20 yers. Nothing changed there. The heads...
I blame the painter!! (and now the cam lobe!)
I am using the bedliner along with the "cheaper" dynomat. The shop wanted $500 for the "good stuff" Since I drive my car less than 2000 miles a...
Paul, I agree. It is something simple that I am just missing. I am having the cam lobes miched today for lift. By eyeing it though, they looked...
New heads, no lash caps.
Solid!
Cam IS out. I checked all that prior to pulling it out. Rocker arm is fine, pushrod is ok, screw-in stud is still screwed in! Errr..
I posted on here a few days ago with the problem of a flat cam lobe. Basically I could run the rocker arm down to the pedestal and still lift the...
Done! Talked to Comp Cams and they reccd the 282s 236/236 dur at .050 .528/.528 lift and 110 LSA They said that with the new heads split duration...
Time and expense is one reason. Also, I have had good luck on the solid side. i.e. this cam, 20+ years! Thanks for the comments. Anyone running...
I am looking at the Comp Cam 282s and it has VERY close specs to the above cam. Int/Exh duration at .050 236/236 lift at .528/.528 Talked to a...
Sam specs, also 4 weeks! I am going to go with a comp cam. I did call them today. Posted their reccd in the other post
Separate names with a comma.
