Engine Horse Power

Discussion in 'New Members Forum' started by Zip4747, Mar 9, 2012.

  1. Zip4747

    Zip4747 Member

    Joined:
    Feb 29, 2012
    Messages:
    91
    Likes Received:
    3
    Trophy Points:
    25
    Location:
    Philly PA
    Vehicle:
    1971 Ford Maverick
    I recently bought a 1971 Ford Maverick alledgely with the original 302 Engine in it that was rebuilt. But when they rebuilt it they changed the compression ratio of the piston & changed the cam. Does anyone know how to find out the horsepower the engine might make?

    2nd question it has a 600 cfm elderbrook carb on it does anyone know if changing it bigger or smaller will help or hurt the power?


    Thanks for your help
    Joe
     
  2. Mavman72

    Mavman72 Gone backwards but lookin' forward

    Joined:
    Apr 24, 2007
    Messages:
    6,759
    Likes Received:
    272
    Trophy Points:
    273
    Location:
    Buffalo N.Y.
    Vehicle:
    1972 Maverick 2 door.Original V-8 3 spd std shift.Also a 72 one owner Sprint sporting a 351 Windsor
    Dyno... either engine or rear wheel dynamometer. Anything else is just a guess.
     
  3. 71gold

    71gold Frank Cooper Supporting Member

    Joined:
    Apr 9, 2002
    Messages:
    26,590
    Likes Received:
    2,935
    Trophy Points:
    978
    Garage:
    1
    Location:
    MACON,GA.
    Vehicle:
    '73 Grabber

    ...:yup:...
     
  4. Zip4747

    Zip4747 Member

    Joined:
    Feb 29, 2012
    Messages:
    91
    Likes Received:
    3
    Trophy Points:
    25
    Location:
    Philly PA
    Vehicle:
    1971 Ford Maverick
    Thank You So Much for all your help! :burnout:
     
  5. Craig Selvey

    Craig Selvey Indiana State Rep - MCCI

    Joined:
    Mar 9, 2002
    Messages:
    18,313
    Likes Received:
    1,373
    Trophy Points:
    878
    Location:
    Albany, Indiana
    Vehicle:
    1972 Maverick Grabber - Color: Orange Also, 1976 Ford Maverick 4-door, 1977 Mercury Comet 2-door.
    What you are going to do with this car would determine any more work/changes to be done. Daily driver? Weekend driver? All out 100% drag car? Each one would be set up and equiped differently.
     
  6. Zip4747

    Zip4747 Member

    Joined:
    Feb 29, 2012
    Messages:
    91
    Likes Received:
    3
    Trophy Points:
    25
    Location:
    Philly PA
    Vehicle:
    1971 Ford Maverick
    I would drive it on the weekends. NOt a daily probably never actually race it.
     
  7. don graham

    don graham MCG State Rep

    Joined:
    Mar 10, 2002
    Messages:
    15,800
    Likes Received:
    16
    Trophy Points:
    302
    Location:
    arizona city, az.
    Vehicle:
    70 mav, 71 grabber, 73 Comet, 2004 f-250 crew cab diesel, 2001 f-250, 2004 explorer, 2007 Gold Wing trike.
    Welcome to the board. 600 should be okay for your purpose. I doubt they changed the cam and compression to be too radical.:Welcome:
     
  8. Craig Selvey

    Craig Selvey Indiana State Rep - MCCI

    Joined:
    Mar 9, 2002
    Messages:
    18,313
    Likes Received:
    1,373
    Trophy Points:
    878
    Location:
    Albany, Indiana
    Vehicle:
    1972 Maverick Grabber - Color: Orange Also, 1976 Ford Maverick 4-door, 1977 Mercury Comet 2-door.

    Agreed. With what you intend to do with the car...just leave it as is.

    I bet when they rebuilt it, they did not necessairly change the compression ratio of the pistons. I bet they just put oversize pistons in it (like .030 over). Pretty common with a rebuild. Probably put a little better than a stock cam in it. The only thing I would consider is maybe adding some headers....but that would be it.
     
  9. Zip4747

    Zip4747 Member

    Joined:
    Feb 29, 2012
    Messages:
    91
    Likes Received:
    3
    Trophy Points:
    25
    Location:
    Philly PA
    Vehicle:
    1971 Ford Maverick
    Thanks Everyone for your help.
     

Share This Page