I am building a gasser Maverick 1969 1/2 . I been welding new floors , vents etc. this car has been sitting in a leaky car port for 25 years so it has typical water leaks from rust out under dash but low miles . I want to add strength to the body . I am also doing a gasser axle from speedway . is there a roll bar kit? where do I weld it in . can I get frame connectors? as i see they have for Mustangs. Thanks Bill on Long Island
S&W Race Cars makes a very good roll cage for Mavericks. I have put in 4 of them. They sell 8 and 10 point cages and from there you can get the other bars for a 12, 14 etc... as far as the sub frame connectors you have to build your own. There are a few people on here that make and sell them. Good luck with the build.
If you are making an old school GASSER then I have just the wheels for you. A set of ET slots that are 15X10 with a 3" back spacing. That will give you the whole tires sticking out the fenders look of the old gassers. Here are a few pic of them
