Headers for 250?

Discussion in 'General Maverick/Comet' started by 1973Maverick357, Jun 25, 2009.

  1. 1973Maverick357

    1973Maverick357 Cooler then a Camaro

    Joined:
    Nov 16, 2008
    Messages:
    3,082
    Likes Received:
    1
    Trophy Points:
    89
    Location:
    Cookeville TN
    Vehicle:
    1976 stallion,1973 2dr mav,1975 2 dr comet,1964 F100,1970 Mav Grabber
    I found some headers for 170-200 will it fit on a 250?
     
    1973Maverick357, Jun 25, 2009
    #1
  2. JHodges

    JHodges thumper

    Joined:
    Oct 14, 2006
    Messages:
    1,902
    Likes Received:
    5
    Trophy Points:
    132
    Location:
    Dora Alabama
    Vehicle:
    1972 Maverick 351w swap, 1965 Mustang 355 glide, 1993 civic daily driver
    It will physically bolt to the head but might not work because of the starter location on the 250
     
    JHodges, Jun 26, 2009
    #2
  3. 1973Maverick357

    1973Maverick357 Cooler then a Camaro

    Joined:
    Nov 16, 2008
    Messages:
    3,082
    Likes Received:
    1
    Trophy Points:
    89
    Location:
    Cookeville TN
    Vehicle:
    1976 stallion,1973 2dr mav,1975 2 dr comet,1964 F100,1970 Mav Grabber
    Yeah i figured that out...If i can come up with enough money i will buy the headers and try it.
     
    1973Maverick357, Jun 26, 2009
    #3
  4. JHodges

    JHodges thumper

    Joined:
    Oct 14, 2006
    Messages:
    1,902
    Likes Received:
    5
    Trophy Points:
    132
    Location:
    Dora Alabama
    Vehicle:
    1972 Maverick 351w swap, 1965 Mustang 355 glide, 1993 civic daily driver
    If you are going to fool with 6's I'd reccomend the fordsix forum. You can learn a lo over there about them
     
    JHodges, Jun 26, 2009
    #4
  5. jncastell

    jncastell Member

    Joined:
    May 28, 2008
    Messages:
    1,016
    Likes Received:
    0
    Trophy Points:
    100
    Location:
    Ogden, Utah
    Vehicle:
    1974 Maverick Grabber Clone
    :) And you should also look at Classicinlines.com lots of upgrades for a Ford 6.
     
    jncastell, Jun 26, 2009
    #5

Share This Page