Another a/c question

Discussion in 'Technical' started by mavtricks71, May 13, 2007.

  1. mavtricks71

    mavtricks71 Member

    Joined:
    Aug 3, 2004
    Messages:
    1,511
    Likes Received:
    7
    Trophy Points:
    117
    Im putting in a high pressure switch on my a/c dryer and the switch has two wires, im not sure where there supposed to go, :hmmm:
     
    mavtricks71, May 13, 2007
    #1
  2. Slantsickness

    Slantsickness Member

    Joined:
    Apr 5, 2007
    Messages:
    164
    Likes Received:
    1
    Trophy Points:
    0
    Location:
    Tucson, Az
    Vehicle:
    1975 2 Dr.
    Most binary switches are put in series with the compressor clucth wire.
     
    Slantsickness, May 14, 2007
    #2
  3. mavtricks71

    mavtricks71 Member

    Joined:
    Aug 3, 2004
    Messages:
    1,511
    Likes Received:
    7
    Trophy Points:
    117
    yea 1 goes to clutch...not too sure where other one leads
     
    mavtricks71, May 14, 2007
    #3
  4. Slantsickness

    Slantsickness Member

    Joined:
    Apr 5, 2007
    Messages:
    164
    Likes Received:
    1
    Trophy Points:
    0
    Location:
    Tucson, Az
    Vehicle:
    1975 2 Dr.
    The other one goes to the wire from the firewall that comes from the a/c switch inside the car.
     
    Slantsickness, May 14, 2007
    #4
  5. mavtricks71

    mavtricks71 Member

    Joined:
    Aug 3, 2004
    Messages:
    1,511
    Likes Received:
    7
    Trophy Points:
    117
    yup! i got it figured out! thx
     
    mavtricks71, May 14, 2007
    #5

Share This Page