Wiring harness

Discussion in 'Technical' started by superlead76, Jun 9, 2006.

  1. superlead76

    superlead76 Member

    Joined:
    Aug 1, 2005
    Messages:
    372
    Likes Received:
    1
    Trophy Points:
    75
    Location:
    Tampa, FL
    Vehicle:
    1972 Maverick Grabber 347!
    I was checking out the I6 to V8 swap thread and noticed that you have to use, or make, the V8 wiring harness. This is not a problem for me because I have a donor car but was wondering...do you just take the whole harness out from under the dash or what? I'm going to to the swap over the next 2 weekends so any help would be appreciated. Thanks guys.
     
    superlead76, Jun 9, 2006
    #1
  2. dmhines

    dmhines Dixie Maverick Boy

    Joined:
    Jun 24, 2002
    Messages:
    8,927
    Likes Received:
    22
    Trophy Points:
    147
    Location:
    Cumming, GA
    Vehicle:
    1971 Grabber / 2012 Mustang / 2009 Jeep Wrangler / 2013 Ducati / 2009 Buell XB12Scg
    All you need is the V8 sensor harness which unplugs inside the engine comparment. The rest of the harness is identical ...
     
    dmhines, Jun 9, 2006
    #2
  3. superlead76

    superlead76 Member

    Joined:
    Aug 1, 2005
    Messages:
    372
    Likes Received:
    1
    Trophy Points:
    75
    Location:
    Tampa, FL
    Vehicle:
    1972 Maverick Grabber 347!
    Great! Thanks.
     
    superlead76, Jun 9, 2006
    #3

Share This Page