transmissions

Discussion in 'Parts Interchange' started by inline6, Jul 12, 2003.

  1. inline6

    inline6 Member

    Joined:
    Oct 19, 2002
    Messages:
    586
    Likes Received:
    0
    Trophy Points:
    0
    hi guys,i am looking for a tranny(3or4 speed on the floor).i have a chance to get a three speed out of a 66 mustang,unfortunatly it looks just like the one that came out of my 69.5,with the 200 six.
    is there a bellhousing that will bolt to it to mate it to a 302,or should i look for one mated to a 250,or 302?any and all answers and advice is appreciated.drive safe...chuck.
     
    inline6, Jul 12, 2003
    #1
  2. schwinnfever

    schwinnfever New Member

    Joined:
    Jul 15, 2003
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Susex Co. New Jersey
    Vehicle:
    Fords & Mercurys only
    Hi, My parts aren't for sale but wanted to say that I have a 3 speed pulled from a 74 250 IL6 and it sits on my bench next to a top loader 4 speed from a 69 Torino and they look to have the same shaft, bolt pattern, and lenth from the tip of the shaft to the flat that bolts to the bell... good luck, Phil
     
    schwinnfever, Jul 16, 2003
    #2
  3. Mavaholic

    Mavaholic Growing older but not up!

    Joined:
    Mar 9, 2002
    Messages:
    14,993
    Likes Received:
    212
    Trophy Points:
    258
    Location:
    Live Oak, FL
    Vehicle:
    Original 72 Sprint Owner, 71 Comet GT, 57 Ranchwagon, 57 4 dr Wagon
    The manual transmissions are the same for all engine sizes in the Maverick and, for that matter, Mustangs. Both 3 speed and toploader 4 speeds (ones from Mustangs) are interchangable. Even the BW T10 will interchange. Top Loaders from other full sized Ford prducts will bolt up but may have a longer tailshaft.
     
    Last edited: Jul 16, 2003
    Mavaholic, Jul 16, 2003
    #3

Share This Page