Motor mount wont line up

Discussion in 'General Maverick/Comet' started by smegnl, May 9, 2020.

  1. smegnl

    smegnl Roger Saffle

    Joined:
    Apr 3, 2010
    Messages:
    2,326
    Likes Received:
    337
    Trophy Points:
    212
    Location:
    Wadsworth, Ohio
    Vehicle:
    1970 Grabber Clone
    I have tried and tried, pried and pried. Jacked up the trany, lowered the trany. Jacked up the car, jacked up the engine under the oil pan. Nothing I do can make this half a hole difference. What am i doing wrong? This is the drivers side.

    upload_2020-5-9_15-33-48.png
     
    smegnl, May 9, 2020
    #1
  2. RMiller

    RMiller My name is Rick

    Joined:
    Dec 12, 2009
    Messages:
    4,132
    Likes Received:
    1,160
    Trophy Points:
    538
    Garage:
    1
    Location:
    Kennewick, WA
    Vehicle:
    1971 Maverick Grabber
    Loosen the bolts to the frame and the bolts at the block, that should give you the wiggle room to make it happen.
     
    RMiller, May 9, 2020
    #2
    yellow75 and BKelley like this.
  3. ike72com

    ike72com Member

    Joined:
    Sep 22, 2019
    Messages:
    408
    Likes Received:
    247
    Trophy Points:
    111
    Garage:
    1
    Location:
    Charleston SC
    Vehicle:
    1972 Comet, 70 mustang, F250 and F100
    I used smaller bolt.
     
    ike72com, May 9, 2020
    #3
  4. smegnl

    smegnl Roger Saffle

    Joined:
    Apr 3, 2010
    Messages:
    2,326
    Likes Received:
    337
    Trophy Points:
    212
    Location:
    Wadsworth, Ohio
    Vehicle:
    1970 Grabber Clone
    thanks that worked there all in and I just got tighten everything up after I get the headers on.
    THANKS!
     
    smegnl, May 9, 2020
    #4
    RMiller likes this.

Share This Page