Did you use the bearings that came with the R&C Kit? Instructions say they are a different size than the standard MII bearings, and a bearing...
Shoot a picture of the carb, and if it is torn down, include all the parts, including the plates and/or blocks. If I recall, the part number is...
No comment. Just subscribing to thread in case you figure it out, and I have the same issue after I install my ssbc brakes.
I am sure that any mustang parts shop would have them. I just checked John's because he is local.
Yes, got them and jay received them yesterday. After losing one set, i wanted tracking info on the second set. Also, i wanted to see them and...
Why are you guys plugging yours up?
I wouldn't and didn't. I borrowed a 220 Amp mig.
Not reading all the posts. Just answering the question... Too many oils, too many opinions, and in my opinion "any oil is better than NO oil!"...
Mine is slow to engage if I haven't driven it in 6 months, and lots of fluid has leaked out. So, first and foremost, check your fluid level. The...
I am in the process of an R&C RC-106. Pretty much the same as above, but his has coilovers, mine has regular shocks. It is a bit of work. He...
Mine is not installed, so probably easiest to measure. 44-1/2"
RC-123 is 1" diameter. Same one I have.
I found a dark gray one, with black stripes over the top, in a multi-pak. Can't find it in a single pack, yet.
I sent the stock bolts to Jayss10 and they apparently got lost in the mail. So I ordered a set from John's Mustangs today and they will be shipped...
400 at the wheels is going to be a FUN ride in that light car!!! Nice A/F ratio, for the most part. Is that thing fuel injected? I cannot...
Those are VERY nice welds... I am jealous! :bawling:
I have to do that next. There are a LOT of spot welds holding that strut rod in, and I am not looking forward to that job. Almost tempted to...
Good news! I just MIGHT have my Maverick back on the road by then! If all the parts come in on time, I have next week off for Spring Break (at...
I did the same thing. I am getting ready to cut out the strut rod support, and that added metal will be all that I have up there keeping things...
I have the mounting bracket, and the power rack. I will need a pump, hoses, a filter, and a cooler. And a longer accessory drive belt....
Separate names with a comma.
