Sorry guys didn't catch the draw thru part!
We just pulled a 5.0 out of a Mustang yesterday and there's evidence of the flywheel rubbing on the block plate. It was pretty bad actually. It...
Yep! They raise fuel pressure on a 1:1 ratio when referencing boost. That's the best way to go. A wide band o2 sensor is a very good idea for...
Good call I didn't think about the trailer supply place! I'll check in the a.m.
Well if I can come up with a set of leaf spring pads in the next couple days we'll know for sure if they fit!
Sorry for the poor terminology. I understand the effect of the section width. 275's just seem to work better in a racing situation on 10" wheels,...
What rear end are you running, and what is the backspacing on your wheels? I figured fender rolling would be needed anyway.
It works in my head :hmmm:!! I just need some assurance lol
I wasnt quite sure where to put this question, but this seemed like the best place. I have an Explorer 8.8 that i plan to install in my '70 Mav....
Sorry I'm no help with the pump, but noticed the nitrous comments.....Many hard core nitrous systems are flowed at around 5-5.5psi through a .073...
Thanks for the warm welcome everyone!
Thanks! I'm down in Ft. Lauderdale. I'll have to look into the January event. What kind of motor setup are you running to 6.90's?
Hopefully 6.50 or quicker to the 1/8......eventually!!
Just wanted to say hello. I recently picked up a 1970 Mav as a roller. My goal is to build a nice street/strip stock suspension 275 drag radial...
Separate names with a comma.
