No rush to do it, just letting you know it can be done. It use to be a lot cheaper to get those alternators rebuilt vs the newer ones but I...
Voltage regulator. The older alternators had the voltage regulator out side of the unit. Newer cars they are all in one. For Ford that started...
It doesn’t sound love your switch problem, but one upgrade I did to my 72 was instead of a bulb or led bulb replacement I got a LED light panel...
They bolted right up, no problems there. I had to change out the main valve block from a Drum/Drum one to a Disk/Drum one. [IMG] Then ran...
I installed that exact same eBay kit in mine. I went with a later model maverick/comet master and a new valve for disk/drum setup.
I never had to change my heater core but there should be a video somewhere. also on eBay here is a picture of the HVAC pulled to give you idea of...
The one I ordered was for manual disk as well, but the rod was still longer than the original and raised up the pedal way up high. just compare...
One thing to check is I went from manual drum brakes to manual disk brakes. The push rod length for the master cylinder was too long and I had to...
The FMX uses the 164 tooth flywheel. I still run one on my 302 in my 52 F1. (In my case it’s a 1989 5.0 (50 oz balance)so the AOD flex plate fit...
Yep 1985 https://www.autozone.com/external-engine/distributor/p/duralast-gold-new-distributor-bdlg-fd30/194020_0_0 for example, even says steel...
If you want a dura spark 2 distributor with the roller cam gear on it get a distributor from a parts house new for a 1985 mustang GT with manual...
A few years back I decided to go with LED bulbs in my project 52 Ford F1 project. Everything worked fine with standard bulbs. (My turn and flasher...
I would make a list of the date code numbers off the Intake manifold Heads Block Exhaust manifold Distributor Carb Flywheel Bell housing Front...
If the car had the 250 six in it originally not the 200 the bell housing would of bolted right up to the 302/5.0. Besides the flywheel make sure...
I think that is the exact disk brake kit I ordered on eBay to swap my 72 comet. I didn’t order a new valve, but had a old one I pulled from a...
I have had to put a small flat tip in to bend the little clip before to get the rod out, broke a ear off the master before it came out. They can...
On The 72 Comet GT I just sold I did a disk brake upgrade and got a later model manual disk master to go on it. (It was originally manual Drum) I...
A old mechanic trick is to back the nut off and slide it back some. Where the nut on the hose goes wrap it in thread or Teflon tape. Then slide...
I personally never used wet lube on a speedometer cable. I have always used dry powdered graphite like this....
On your plugs try to use the brass ones. In the future if you have to take one out and it's stuck. It's a lot easier to drill out than steel. They...
Separate names with a comma.
