howd this go? i wanted to go but i was outta country..
so all in all did i get completely screwed or are they at least decent and with the rest of what i said what kinda power numbers do you think ill...
yeah the problem is since it went through ebay theres not a whole lot that can be done we payed he gave what was ordered and aside from that...
yeah the problem is the guy ordered em without talkin to me first and the other guy wont give him his money back just another set of heads he has
yeah i knew about the issues with the p heads those were one of the other sets of heads that came and went while i was in germany im starting to...
im back from germany and amazingly the 250 in my maverick is still running even with the number 2 and 3 piston rings being blown and all
ok so what do you guys think about the gt40 heads? i had a huge problem with the heads for my car because i had someone else dealing with my...
has anyone tried the black maverick valve covers they have on ebay? good bad? i kinda like the way they look.
i was also lookin at that summit circle track radiator where did you fab your brackets to mount to? does anyone know if theres any aluminum water...
i use a 100 lb torque stick.
yeah i gave my artist some basic drawings last night and hes gonna start piecin em together for the final artwork and lemme know how much its...
well about to go to my tattoo artist today and give him some pictures for my next tattoo thought some of you might be interested in this one. i...
thats what i thought too i had to do a lot of inputting of numbers on my parts but all the numbers i put in i looked up factory specs for the...
my numbers were way way different than that i got 393 ft/lbs@5500 and 439 hp@6000 and averages were 346 ft/lbs and 317 hp
hey ratio i also have engine analyzer but i have 3.3 and im still trying to figure it out but what do you get with my setup that i listed earlier,...
how bout 302 bored .030 over comp cams xe274h .520/.523 230/236 at .050 performer rpm edelbrock 1405 carb performer rpm heads 2.02 valves 9.5:1...
mine did that a couple weeks ago turned out to be a bad condenser. also adjust your carb make sure your air/fuel screw isnt shut or wide open idle...
i dont have any pics either but right now i just have an atd cart with 3 locking drawers..just started workin at the shop not too long ago
its in a junk yard come on open it with a crowbar:D
yeah ive seen a couple people get away with it fine i always do it as a precaution and ive seen a couple people have it bite them in the a$$ and...
Separate names with a comma.
