What is the correct way to install PS pump pulley?

Discussion in 'General Maverick/Comet' started by scooper77515, May 4, 2013.

Page 2 of 2
  1. scooper77515

    scooper77515 No current projects.

    Joined:
    Jun 30, 2004
    Messages:
    14,672
    Likes Received:
    73
    Trophy Points:
    233
    Location:
    Issaquah/Grand Coulee, WA
    Vehicle:
    Fresh out of Mavericks
    Yes, waiting to get the correct sized belt before I run the pulley all the way down, so I can crank it on to it's final destination and only have to do it once. Correctly.
     
    scooper77515, May 4, 2013
    #16
  2. blugene

    blugene Senior member Supporting Member

    Joined:
    Jul 25, 2004
    Messages:
    10,774
    Likes Received:
    84
    Trophy Points:
    283
    Garage:
    1
    Location:
    Marietta, OK
    Vehicle:
    73 Comet GT, 72 Comet GT, 2008 "Comet" (our boxer, who is now in the galaxies)
    blugene, May 4, 2013
    #17
  3. blugene

    blugene Senior member Supporting Member

    Joined:
    Jul 25, 2004
    Messages:
    10,774
    Likes Received:
    84
    Trophy Points:
    283
    Garage:
    1
    Location:
    Marietta, OK
    Vehicle:
    73 Comet GT, 72 Comet GT, 2008 "Comet" (our boxer, who is now in the galaxies)
    So did you look to see if the bolt heads will clear on the back side? I believe this is why there is the space that you have facing out.. But like I said, I have not seen this type pulley so maybe it has space on both sides..
     
    blugene, May 4, 2013
    #18
Page 2 of 2

Share This Page