water pump pulley????

i just switched from power steering to manual and i need a new pulley wheel from my water/fan so that i can run it where can i find this part??? its a 302 just if that helps

 

If you can determine what depth this pulley needs to be, I have several extras.

 

Measure from the front of the waterpump flange to the center of the V belt groove on your crank pulley.

 

ok i can do that tonight and get back to you thanks

 

i measured it 1 1/4 inches for the center pulley wheel of the crank

 

Measure to the center of the rearmost crank pulley, that's the one used for alternator only setups.

 

I got mine from NPD (National Parts Depot). You have to measure from the mounting surface of the water pump to the center of the groove that the alternator belt runs in. Good Luck,
Lee "THE MAV" Richart

 

i was about to ask the same Q i need the other water pump pulley to ??

 

yea the alternator runs off the middle groove of the crank and the measurement is 1 1/4

 

All the pulleys I have are deeper than that and run off the rearmost crank sheeve. That's the way I'm running the setup on my 331 using 70's 302/351 pulleys.

 

well then how do i mount my alternator or where do i buy a full set so i can run it????

 

can anyone help me????

 

and help me ( 2 BIRD'S WITH ONE STONE )

 

The alternator bracket sets sold for the 302's are what you need. These include a triangle shaped stamped steel bracket that mounts to the waterpump, along with an curved long adjustment bracket that goes onto the bottom bolt hole of the triangle bracket. The Big alternator bolt goes thru the outer hole of that bracket into the head, with the alternator spaced off the head with a thick aluminum spacer (about 1" long). If I was more computer litterate, I'd look one up and post a pic of this here. Maybe I'll have time to do that tomorrow.

 

Look up Ford Racing P/N M-10313-A302.